![]() Indicates “low battery” and will typically not turn OFF until new alkaline batteries are installed. User Code and remains ON until you have entered a 5-digit passcode. Comes ON in the Program Passcode mode after you have entered your. ![]() Comes ON in the Program User Code mode after you enter the Factory Code and remains lit until you have finished entering a 5-digit User Code.Comes ON after you enter a valid code/passcode and remains lit during the 4-second period in which the safe can be opened.After entering each digit of Factory or User Code, or Passcode.You have let 5 seconds or more elapse between key entries.You have entered an invalid code or passcode.You have pressed Program key out of sequence.Red (Error) LED + three beeps indicates one of the following: Your electronic-lock safe communicates by means of several audio/visual signals. Unlock the door by inserting the key provided into the hole and turning clockwise. Remove the keypad by rotating the cover counterclockwise, then pull toward you. If your electronic lock fails or you do not have any codes available, you may use a key override to access this unit. (If you realize you have made an error while entering your code, press the CLEAR button and start over.) Key override If you fail to do so in time, the lock will reactivate. ![]() ![]() Once you have done this, you have 4 seconds to open the safe by turning the handle or 4-bitted key to the unlock position. To unlock the safe, you must enter a valid Factory Code, User Code or Passcode. To erase the passcode, press Program twice, enter your User Code and then enter 00000.) Unlocking (To enter a new passcode, repeat these steps.
0 Comments
Leave a Reply. |